![]() ![]() In fact, the DStv technician will perform some advanced diagnostics to identify the problem. Have you have tried all the tips above without any success? If that is so then maybe it is time to call an accredited DStv installer in your area. Remember, you also need to align the LNB correctly by tilting it up and down. If your LNB is faulty then you need to replace it to restore the DStv signal. ![]() So, make sure they are connected properly on the LNB. These nuts which connect your DStv cables to the LNB. There are silver metallic nuts that you find at the end of your DStv cables. Although you might not know how to align your satellite dish yourself, at least, you will know the source of your signal problem. You will need a signal detector to realign your dish. If the dish is freely moving then realign the satellite dish and then tighten the bolts. Otherwise, strong winds can easily put your dish out of alignment. Your dish should not move freely when you try to turn it. Rust affects most satellite dishes in coastal areas that are made out of galvanized iron.Īlso, make sure that the bolts on the satellite dish are tight. ![]() Visually inspect your satellite dish for a broken arm and rust. So, be patient! If this does not solve your problem, then proceed to the next step. Remember, rebooting your decoder may take a while. So, why not try it out! Reboot your decoder by pressing the power button for more than 10 seconds. Just make sure that you plug in the signal cable on the right port ( LNB-in and Unicable-in).īelieve it or not, rebooting your decoder can solve multiple problems such as freezing pictures and decoder errors. If you find any loose cables then plug them back onto the DStv decoder. Remember kids, dogs and cats can pull your DStv cables at the back of your decoder. In fact, make sure all cables are connected to the correct ports on the decoder. How to connect F-type connectors on a DStv coaxial cable Incorrect decoder settings can be fixed by resetting your decoder to factory defaults as shown in the video below. This is caused by either a misaligned satellite dish, a faulty LNB, an improperly connected F-connector plug, loose cables or incorrect decoder settings on the LNB type. The reason your DStv says no signal is because there is an error in the DStv installation. See how you can improve your DStv signal strength and quality. This is because when your decoder resets, it uses the default LNB type settings which may not be appropriate for your decoder. If your decoder resets itself to default factory settings then you can also lose your DStv signal. What causes your DStv decoder to lose signal?
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |